If you decide to go this route you should also stain or paint the posts and rails prior to attaching the boards. Keep each stake in position allowing the concrete to dry. First stake the spot where you like your fence to start. Posts of 2″x2″ timber that are about three foot six inches long, hammered into the ground should do it. Along the run of wire, you can plant two or three evergreen shrubs that will not grow very high. • Erect each post making sure that the top part of each pole is aligned with the other. Fence Building A third may be the vegetable patch. In most areas you need to have the postholes below the frost line to make sure that the post will stay in place when the ground starts to heaves due to the frost. There will be three areas where most people like the fence as high as it is allowed. This will help you calculate the materials needed to build your fence. Dig the holes about 28 inches deep. • Affix the fence posts by burrowing holes that are larger at the bottom. Fence Building Now, insert the posts for the first section. Use a spacer to get a consistent distance between them and shovel dirt around them when you have the posts in position.
The basic theory is that you stake out where your fence will be and stretch a string between them. Next you need to treat your posts by following the manufacturers recommendations. The line post doesn’t need that much support. Do the same with posts that will manage big burdens. Fence Building Assuming this part is all done. Each of the above mentioned raw materials has a different cost. The wire can be attached by a stapling gun. You often are allowed to have a higher back fence than sides or front etc, so you will need to know all this. • Dig the holes to the appropriate deepness. It’s now time to prepare your concrete for setting the posts. Fence Building Another reason for this is that while many people do not actually want a fence, sometimes, one becomes necessary.. Now that your fence is up you probably want a gate. Mark the position of your first spot, then measure out for the line to mark the rest of the posts.
Follow the directions on the bag of concrete to get it to the proper consistency. When you have all posts set hard, trim of the tops to get proper height. Fence Building Make sure to set the bottom rail 8 inches above ground and be careful to have both ends the same height from the ground. Once you’ve decided on the style of vinyl fencing that you want, you’ll need to get the materials from your local home improvement center. Hold a tape measure diagonally between the one-meter mark and the 1,5-meter mark and move the string until the distance between the marks is 2-meter. Afterwards, stretch a line in between these posts. Low level fir trees about three foot high are fairly inexpensive, and you can dot these along your fence posts. • Set your posts between 6 to 8 feet apart. Fence Building Or you can place two to three shovels of gravel at the bottom of each hole to prevent rot and decay.. • Treat the part of the fence post that will be buried using wood preservative. If your fence starts with your house you will probably like to have it at a right angle. Use a level to make sure each post is plumb and barely touching the string. Your back row must be evergreen, because you need to hide the fence all year.
Fence Building